Installing Your Unit

4.0.0

Installing Your Unit

4.1.0

You have now determined the desired location of the unit. The chiller comes with casters and can be rolled into position. If it is necessary to lift the \ unit this hould be done by the bottom frame only. If you must use lifting cables or chains, be careful not to damage components, controls or pipes.

4.2.0

Check to ensure that power supply agrees with nameplate. Supply voltage must be within plus or minus 10 percent.

4.3.0

Power should be supplied through a fused disconnect.

4.4.0

Check power source for voltage unbalance.